Car Dynamics
Maximum foam with minimal effort:
The FoamXCannon Snow Foam Lance delivers 1L of thick, even foam coverage with just a twist and spray. It’s your essential weapon against dirt for an effective prewash and sealant process.
Working in conjunction with either ProSno or ProAlpine snow foam, FoamXCannon quickly generates thick and intense coats of clingy foam, maximising the surface area and dirt your snow foam clings to.
Built with four adjustable spray modes, FoamXCannon ensures you get comprehensive coverage of your vehicle while easily following its contour lines to cover small crevices and hard to reach areas.
As well as enabling a fantastic prewash, FoamXCannon can also be used with NanoBead after a shampoo and wash to provide an effective invisible protective polymer coating. In this instance, FoamXCannon is quintessential in spreading an even hydrophobic layer onto your paintwork, causing water to bead and roll off, dramatically reduce your drying time.
Supplied with both a ¼” quick-connect and Kärcher K Series adaptor (K2-K7 range), FoamXCannon is compatible with a wide range of pressure washers. Using the custom mixing dial to easily control your dilution, FoamXCannon is the simple to use yet effective foam lance that’s ideal for both the DIYer and the seasoned detailing pro.
To set up the lance, first attach the pick-up tube to the Nickel-plated copper suction nozzle on the underside of the foam lance head.
Select the correct connector for your pressure washer (the kit includes both a ¼” and Kärcher K-series connector). Next, attach the black end of the connector to the handgun of your pressure washer. Pull back the spring-loaded brass collar on the connector and attach it to the silver nozzle on the Foam Lance head.
A: Yes. FoamXCannon comes with an adaptor for all models in the Karcher K-Series of pressure washers as well as a 1/4" adaptor which is suitable for most pressure washers. Additional connectors specific to your pressure washer are available to buy here from the Snow Foam Lance & Adaptors section of our website.
A; No. FoamXCannon is a foam lance and hence needs to be used with a pressure washer to provide the required pressure.
A:Yes. By pre-washing the car in a thick foam, FoamXCannon helps lift and loosen dirt before hand contact. This minimises swirl marks during the wash stage. For best results we recommend either ProSno or ProAlpine as your snow foam.
A: Yes it is vital that you flush through the FoamXCannon after use with clean water and rinse the water bottle reservoir. Left over solution can block the filters and reduce the effectiveness of FoamXCannon.
We accept the following paying methods
